Currently there are the following commands supported:
Status command. Returns firmware revision number and
the following statistical data: number of taken pictures, number of
activities (alarms), number of power failures, number of SMS requests,
number of unknown SMS requests in form today's number/total number,
current system's state (active or inactive>, current sensor states;
Activate command. Sets the system into active state
if it was inactive before;
Deactivate command. Sets the system into inactive state
if it was active before;
Snapshot command. Takes a photo remotely and uploads
it to the server immediately. Not available in simple mode;
Set output [1|2] [ON|OFF] command. Sets output 1 or 2
to high or low level;
Sysinfo command. Returns firmware revision and copyright
data, current state of LED1 and LED2 (enabled or disabled), current timestamp,
power source (main or backup) and current level of mobile battery;
Temp command. Returns current temperature if either DS18S20
sensor is installed or the mobile phone has its own sensor which is accessible
via AT commands.
Set time YY/MM/DD,HH:mm:ss command. Sets microcontroller's
real time clock.
RTC is set automatically by fetching current timestamp from mobile phone. This command was introduced to simplify time settings when the controller works in tandem with GSM module which usually desn't have RTC.
Reset command. Forces the controller to perform its